38
Fe
26
AXIS INSTALLATION
7. From the reference marks, subtract 4” [102mm] and mark
cut points on the top and bottom rails. As shown in Fig. 2.
8. Measure distance from rail cut mark to the end of the rail.
As shown in Fig. 3. Write the dimension on paper for future
reference.
9. Using a rubber mallet, remove one of the uprights from
the panel. As shown in Fig. 4.
DO NOT Remove the opposite
upright.
10. Use previously found measurement (Fig. 3.) to mark picket
cut points. Measure from the end of picket inward and
mark the cut points. As shown in Fig. 5.
11. Place the removed upright on top of loose rails & pickets.
12. Position the back edge of upright in line with the
previously marked rail reference marking
and flush with the
rails
. As shown in Fig. 6.
13.
Confirm rail & picket cut marks before cutting the panel.
14.
Using a square, straighten cut point markings on top and
side faces of rails and pickets
. As shown in Fig. 7.
Cut mark
Fig. 1
Mark on rail from
back of bracket
Position
bottom of
Bracket
flush with
bottom of
rail
Fig. 2
Fig. 3
Reference mark
Cut mark
-4” [102mm]
Measur
e dis
tance
