Fe
26
AXIS INSTALLATION
15
Fig. 1
Fig. 2
UNIVERSAL BRACKET: PANEL INSTALLATION
Side View
1/2” [25mm]
Centerline of rail
Step 1:
Determine The Top & Bottom Of Panel
1. Use the Manufacturing Date Code (MDC) Stamp to
determine the bottom of the panel. The MDC Stamp can
be found on the bottom inside face of the middle upright.
As shown in Fig. 1.
Tip:
• The bottom of the panel can also be determined by the
spot welds. Spot welds on the panel should face down and
be on the under side of the rails. As shown in Fig. 2.
Fig. 1
MDC
Stamp
Step 2:
Install I-Support On Bottom Rail (Optional)
1. Measure and locate the center of the bottom rail. Using
the I-Support as a guide, mark the center of the 2 screw
holes. As shown in Fig. 1.
2. Using a 3/16” [5mm] drill bit, drill though the outside wall.
3. Install the I-Support with the provided T-25 thread cutting
screws. As shown in Fig. 2.
Fig. 2
Spot
welds on
under side
of rails
