Fe
26
AXIS INSTALLATION
37
STAIR BRACKET: POST MOUNTING
• Reference Post Mounting instructions on page 5.
Note:
IT’S RECOMMENDED TO INSTALL BRACKETS ON TO POST BEFORE
POST MOUNTING.
STAIR BRACKET: CUTTING DOWN PANELS (SSB-04 BRACKET)
Step 1:
Determine The Top & Bottom Of Panel
1. Use the MDC Stamp to determine the bottom of the panel.
The MDC Stamp can be found on the bottom inside face of
the middle upright. As shown in Fig. 1.
Fig. 1
MDC
Stamp
Step 2:
Measure & Mark Panels Where Cuts Will Be Made
1. Position wood 2” x 4” [60mm x 102mm]
on stairs in line
with bottom brackets.
2. Place bottom rail of panel on top of wood 2” x 4” [60mm x
102mm] next to bottom brackets.
3. Panel needs to be positioned with middle upright centered
between posts
4. Confirm that panel is level and uprights are parallel to posts,
then clamp panel to posts.
5. Place reference markings on rails in line with the back of
bracket opening. Be sure bottom of bracket and bottom of
rail are flush. As shown in Fig. 1.
6. Unclamp the panel and place it on a flat surface, preferably
a table.
