Epsilon-8100 User Manual Revision A.3
www.diamondsystems.com
Page 26
7.1.4 Set-up VLANs
The following example shows the configuration of a VLAN:
1. Connect to the web interface of EPS-8100 switch
2. Navigate to Configuration -> VLANS
a. In the allowed access VLANs enter number of LANs to be created. In this example 1-3, that
creates VLAN2 and VLAN3
b. By default mode is access, it can be changed to trunk or hybrid by changing Mode drop down list
c. Assign a ports to the virtual LANs by changing the values in the Port VLAN column (refer to figure
below)
d. Click on Save to save the VLAN configuration
e. To save VLAN settings permanently navigate to Maintenance -> Configuration -> Save startup-
config click on save startup configuration
Figure 6
–
VLAN Configuration
After saving the VLAN configuration, VLAN membership status can be verified as follows:
1. Navigate to Monitor -> VLANs -> Membership (refer to figure below)
2. Ports 1 & 4 to 8 assigned to VLAN ID 1, Port 2 is assigned to VLAN ID 2 and Port 4 is assigned to VLAN
ID 3
Figure 7
–
VLAN Membership Status for Combined users