Epsilon-8100 User Manual Revision A.3
www.diamondsystems.com
Page 9
4. CONNECTOR AND JUMPER LIST
4.1 Connector and Jumper List
The following table summarizes the functions of Epsilon-8100
’s
interface connectors and jumper. Refer to Figure
2 for the locations of these connectors on Epsilon-8100. Signal functions relating to all of Epsilon-8100
’s interface
connectors are discussed in greater detail in Section 6 of this document. Other connectors and jumper blocks on
Epsilon-8100
are reserved for Diamond’s use only.
Connector
Function
LAN1-8
Ethernet (x8)
RS-232
RS-232 Serial Interface
LED
LED Status Signals and Resets
Power In
Wide voltage power input
J15
Jumper Block J15
4.2 Jumper Block (J15)
The following table summarizes the functions of Epsilon-8100
’s
jumper block, J15. Refer to the Figure 2 for the
location of J15 on Epsilon-8100.
Jumper
J15 Pins
Function
1&2
Reset: Install jumper and power on to reset the switch
3&4
Factory Use Only
5&6
Factory Use Only