Epsilon-8100 User Manual Revision A.3
www.diamondsystems.com
Page 22
6.6.6 Mirroring
For debugging network problems or monitoring network traffic, the switch system can be configured to mirror
frame from multiple ports to a mirror port. Following example depicts Mirror traffic of Port 2 and 3 (Rx) & 4 to 8
(Rx) to Port 1.
# configure terminal
(config)# monitor destination interface GigabitEthernet 1/1
(config)# monitor source interface GigabitEthernet 1/2-3 rx
(config)# monitor source interface GigabitEthernet 1/4-8 tx
6.6.7 Setup QoS
Quality of Service (QoS) refers to the capability of a network to provide better service to selected network traffic
over various technologies, including Frame Relay, Asynchronous Transfer Mode (ATM), Ethernet and 802.1
networks, SONET, and IP-routed networks that may use any or all of these underlying technologies.
Following example shows setting up the QoS, all traffic coming on port 1 is mapped to QoS class (CoS) 2 and
PCP is set as 1.
# configure terminal
(config)# interface GigabitEthernet 1/1
(config-if)# qos cos 2
(config-if)# qos pcp 1
(config-if)# end
6.6.8 Firmware Upgrade
A new WebStax image can be downloaded using the CLI. Copy the Epsilon-8100.dat file to a TFTP server and
use the firmware upgrade command to download the file.
# firmware upgrade tftp://<ip_address>/<path>/Epsilon-8100.dat
#
6.6.9 Factory defaults
User can reset the configuration of the switch by below command. Only the IP configuration is retained.
# reload defaults
#
Note: To load the factory default configuration including the IP address, follow steps explained in section 7.1.11