formlabs Form Wash L, Manual

Page: 38 / 46

36
Error Cause Solution
The platform and
bucket mount do not
move properly.
• Debris or obstructions in the
wash bucket
• Firmware issue
• Check for loose cured material
or debris in the bottom of the
wash bucket.
• Update the firmware
Incorrect solvent saturation
readings
• Bubbles on solvent monitor
• Mismatch between selected
solvent and solvent in wash
bucket
• Check the solvent monitor for
bubbles
• Check that the selected solvent
matches the solvent in the Form
Wash L
7.4.2 Resolving errors
If errors persist after following these steps, contact Formlabs Support or a certified service
provider for additional guidance.
Error Cause Solution
The bucket is already down The Form Wash L attempted
to lower the basket mount and
platform mount when they were
already at their bottom position.
Disconnect and reconnect the power.
The bucket is already raised The Form Wash L attempted
to raise the basket mount and
platform mount when they were
already at their top position.
Disconnect and reconnect the power.
The device position is
unknown
The Form Wash L attempted
to raise the basket mount and
platform mount when they were
in an unknown position.
Disconnect and reconnect the power.
The device is already
moving
The Form Wash L attempted to
raise or lower the basket mount
and platform mount while they
were still in motion.
Disconnect and reconnect the power.
The call to DBus failed Firmware error Disconnect and reconnect the power.
The reply to the DBus was
invalid
Firmware error • Disconnect and reconnect
the power.
• Check for debris or obstructions
that would prevent the platform
mount from moving.
Moving the motor failed The Form Wash L
encountered an error during a
motor movement.
• Disconnect and reconnect
the power.
• Check for debris or obstructions
that would prevent the platform
mount from moving.
The device is not currently
running
The Form Wash L attempted to
cancel an ongoing cycle with no
cycle in progress.
Disconnect and reconnect the power.