Formax FD 3300, Operation Manual

Page: 93 / 100

87
Chapter 5 Trouble Guide
5
Close the top cover.
6
Insert the folding plate 1 and folding
plate 2.
“2-2. Folding plate” (p.82).
2-4. Ejecting section
1
Press the key on the control panel.
The paper is forcibly ejected.
Paper is ejected forcibly as long as the key is held down. Forcible ejection will stop by releasing the key.
3. Troubleshooting
Do not use a flammable static electricity removal spray.
Doing so could cause build-up of gas inside the machine,
which in turn could cause ignition, resulting in fire and explosion.
Condition Cause Solution
Power can not be turned
on.
The power cord is not connected. Connect the power cord.
The machine does not
start operation when the
key is pressed.
Paper is not stacked. Stack paper on the paper feed tray. (p.30)
The paper switch is not responding. Stack paper in correct position so that the
paper switch responds.
Paper has jammed. Remove jammed paper. (p.82)
The top cover is open. Close the top cover.
Non-standard paper is used in standard
paper settings.
Change the settings to match non-standard
paper. (p.46)
The paper feed guide is off the paper size
detection area.
Secure the paper feed guide correctly.
Test folding is not performed even though
the setting is changed to on in [D-Feed
Detect].
Perform test folding. (p.37)
Other non-standard paper is used. Input the paper size.
(p.46)
The folding stopper of the
folding plates 1 or 2 does
not operate.
The folding plates 1 and 2 are not set
properly.
Set the folding plates 1 and 2 properly. (p.82)
Paper is not folded at the
normal folding position.
The folding plates 1 and 2 are not set
properly.
Set the folding plates 1 and 2 properly.
(p.82)
Static electricity is built up on paper. • Use a commercially available static
electricity removal spray.
• Separate the paper well. (p.27)
• Humidify with a humidifier as required.