Section 6
APPLIANCES
Lighting the Cooktop Surface Burners
The Cooktop surface burners can be lit with either a match or the Piezo pilotless ignition. Be sure all
control knobs are in the
OFF
position before supplying gas to the appliance. Be sure the main LP gas
supply is on before lighting the burner.
IF THE BURNER DOES NOT LIGHT WITHIN ABOUT 4 SECONDS OR IF THE
FLAME SHOULD GO OUT DURING COOKING, TURN THE BURNER OFF. IF GAS HAS
ACCUMULATED AND A STRONG GAS ODOR IS DETECTED, OPEN A WINDOW AND
WAIT 5 MINUTES FOR THE GAS ODOR TO DISAPPEAR BEFORE RELIGHTING THE
BURNER.
NOTE: IF THE APPLIANCE HAS NOT BEEN OPERATED FOR A PERIOD OF TIME, THE
SURFACE BURNERS MAY BE DIFFICULT TO LIGHT DUE TO AIR IN THE GAS LINE.
DO NOT TURN THE CONTROL KNOB ‘ON’ AND ALLOW GAS TO ESCAPE BEFORE
LIGHTING THE MATCH.
To Bleed Air from Cooktop LP Line
• Hold a lighted match next to the burner
• Turn the surface burner control knob to the
LITE
position
• When the burner lights, turn the knob back to the
OFF
position
• Depending upon your model, follow the procedure for either ‘Matchlit’ ignition or ‘Piezo’ ignition.
1. Place a pan on the burner grate.
2. Hold a lighted match next to the desired surface burner head.
3. Push in and turn the surface burner control knob to the
LITE
position.
4. When the burner lights, adjust the knob between
HI
and
LOW
to select the desired flame size.
5. After cooking, turn the surface burner knob to the
OFF
position.
1. Place a pan on the burner grate.
2. Push in and turn the surface burner control knob to the
LITE
position. (IMPORTANT: Only
light one surface burner at a time.)
3. Immediately, rotate the TOP BURNER IGNITOR knob to the right (clockwise) several clicks
until the burner lights. The burner should light within 3 clicks or one full rotation of the knob.
CAUTION’ INDICATES A HAZARDOUS SITUATION WHICH, IF NOT AVOIDED, COULD
RESULT IN VEHICLE DAMAGE OR MINOR TO MODERATE INJURY.
Notes:
____________________________________________________________________________________
Page 70
Revised September 2012
