Section 4
LIVING QUARTERS, LP and ELECTRICAL
Before extending the room, check the exterior of the unit to be sure the room will not hit anything outside
when it is fully extended. Locate the rocker switch that reads ‘SLIDE-OUT #1’. Hold the switch in the
‘OUT’ position. (Note: You may hear a low grinding noise at the initial start of the operation. This is
normal. It’s the sound of the piston shafts traveling through the free travel area of the brackets.)
Continue to hold the switch down until the room stops moving. If the room stops moving before it is fully
extended, the piston shafts may need to be adjusted. (Note: If this happens, contact your dealer and set up
a service appointment for adjustment.) To bring the room in, reverse the procedure. If power fails or the
room does not function electrically, you can manually operate the room using the provided hand crank
and inserting it in the access hole located on the door side under the outside entertainment center. See
below:
Turn the handle clockwise to run room out and counterclockwise to run the room in.
NOTE: FOR OPTIMUM PERFORMANCE, THE SLIDE OUT SYSTEM REQUIRES FULL
BATTERY CURRENT AND VOLTAGE. THE BATTERY MUST BE MAINTAINED AT FULL
CAPACITY. IF THE BATTERY IS FULLY CHARGED AND YOU STILL DO NOT HAVE
POWER, CHECK THE TERMINALS AND OTHER CONNECTIONS AT THE BATTERY.
DO NOT PERFORM ANY MAINTENANCE WORK ON YOUR SLIDE OUT
SYSTEM WITHOUT FIRST DISCONNECTING THE BATTERY. FAILURE TO DO SO
COULD RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
WHEN OPERATING THE SLIDE ROOM BE SURE THERE ARE NO
OBSTRUCTIONS IN THE TRAVEL PATH.
Page 38
Revised September 2012
