+8//$66(0%<
Position the hulls in parallel with the inner
sides facing the ground.
Lift the right hull. One person straddles the hull to
hold it in place. The other person applies the silicone
sealant (for waterproofing) around the screw holes.
.
Take the front crossbar (with dolphin striker).
Place it in its support so that the trampoline
track faces the rear of the boat. Insert the two
bolts. Pass your hand through the inspection port to
position the nuts and washers onto the screws
photo). Fasten loosely.
Lift the left hull, and follow the same steps as for the
right hull. Do not fully tighten the screws.
***Respect same order for the washers as assem-
bled at the delivery***
Apply silicone sealant around the screw holes
at the back of the hulls. Place the rear cross-
bar on the right side. Insert the bolts, washers
and nuts as shown for the front crossbar. Do the
same thing for the left side.
Once the frame has been mounted, tighten all the
bolts fully and then install the lock nuts.
NB
: it is advisable to check the fastening of the bolts after the first
trip out onto the water, and recheck these at regular intervals.
Fogh Marine | 416 251-0384 | www.foghmarine.com | [email protected]
