FOCO INSERTO 13, Manual

Page: 96 / 290

24
EN
Safety devices
The chimney insert is
equipped of a
micro switch
that stops the pellet load
when it is extracted.
Flue gas temperature
sensor:
thermocouple that
measures the temperature of
the fumes while keeping the
operation or shuts the Insert
when the fl ue gas temperature
drops below the preset value.
Pressure switch:
monitors
depression in the smoke duct.
It is designed to shut down
the pellet feed screw in the
event of an obstructed fl ue
or signifi cant back-pressure in
the presence of wind. At the
time of the pressure switch
will show
“
A L A R ‐ D E P ‐ F A I L
” .
Electrical safety: the
Insert is protected against
violent surges of current (ex.
lightnings) by the main fuse
4 A which is located on the
control panel at the rear of
the Insert. Other fuses to
protect the electronic boards
are to be found on the boards
themselves.
Pellet temperature safety:
in the rare cases where
excessive temperature occurs
inside the tank, the manual
reset pellets safety thermostat
generates an alarm
"
A L A R ‐
S I C ‐ F A I L
"
interrupting the
operation of the chimney
insert; the restoration must be
performed by the customer
manually.
RESTART
PELLET
Reduction motor:
if the motor stops, the Insert
continues to function until the
fl ame goes out for lack of fuel,
and until It has cooled down
to the minimum level.
Tampering with the safety devices is prohibited. It is only after eliminating the
cause which gave rise to the intervention of the safety system, that it is possible to
relight the Insert and thus reset the automatic operation of the sensor. To understand
which anomaly has occurred, consult this manual at paragraph relating to alarms
which explains what to do based on the alarm message the Insert display.