FOCO INSERTO 13, Manual

Page: 101 / 290

29
EN
For your safety, the frequency
of cleaning the smoke discharge
system must be determined on
the basis of how the Insert is used.
In case of failure or inadequate cleaning of the
heater may have function problems such as:
• poor combustion
• blackening of the glass
• clogging of grate with
accumulation of ash and pellets
• ash deposit and excessive deposits on the heat
exchanger resulting in poor performance.
The check of electromechanical components
must be performed only by qualifi ed personnel
with technical knowledge of electricity and
combustion. Once the cleaning operations have
been completed, reassemble and fi x the parts.
Warnings for cleaning
All cleaning of all parts must be carried out
with the Insert completely cold and the plug
disconnected.
Before effecting any maintenance operation
or cleaning on the Insert, take the following
precautions:
• be sure that all parts of the Insert are cold
• be sure that the ashes are completely cold;
• be sure that the general switch is in the “OFF”
position;
• be sure that the plug is pulled out of the socket
to avoid accidental contact;
• Once the maintenance phase is completed
check that everything is in order as per before
the intervention (the brazier is placed correctly).
Follow carefully the following
cleaning instructions. Failure to
follow these instructions could
create problems with the operation
of the Insert.
Any kind of tampering or unauthorized
substitution of non-original of the Insert can
be hazardous to the safety of the operator and
relieves the manufacturer from any civil or criminal
liability. Use only original spare parts. Replace a
worn before failure promotes the prevention of
injuries resulting from accidents caused by the
sudden failure of the components.
After 1200 hours of operation
of the heater will appear
on the lower display the
word “
S E R V
” , please contact your
Authorized Service Center for cleaning and
routine maintenance.