FOCO INSERTO 13, Manual

Page: 84 / 290

12
EN
It is mandatory to have an opening in the brick /
plasterboard coating to guarantee an adequate
supply of air to the chimney.
It is recommended to replicate the same opening
made on the perimeter wall. Alternatively, the
suction pipe (Ø 50 mm) can be connected to the
outside of the home. If the suction tube is taken
only outside of the brick cladding, it is mandatory
to have an air intake on the perimeter wall of
the house.
Remember that it is forbidden to
inhale the combustion air from
bedrooms, bathrooms, garages or
deposits that could have explosive
atmospheres.
The pellets are cylinders of compressed wood, produced from sawdust and wood
processing (chips and sawdust), generally produced by sawmills and carpenters. The
binding capacity of the lignin contained in wood, allows to obtain a compact
product without adding additives and foreign chemicals to the wood, is
therefore obtained a natural fuel with high yield.
The use of expired pellets or any other unsuitable material can
damage parts of the Insert and impair proper operation: this
can lead to the termination of the guarantee, and its producer
responsibility.
For our products use pellets diameter 6 mm, length 30 mm and a maximum of 8% and A1
certifi ed according to the UNI EN ISO 17225-2 standard. Keep the pellets away from heat
sources and not in humid environments or with explosive atmosphere.
Pellet
Remote Control
The remote control (Fig. 3) used to adjust water
temperature power and the on/off functions for
the pellet Insert.
To start the Insert, press key and the Insert will
automatically enter the starting phase.
Press keys + (1) and - (2) to adjust temperature,
and use keys + (6) and - (5) to adjust operating
power.
To turn off the Insert, hold down key .
To replace the 3 volt battery located on the back
of the remote control, pull the centre of the cover
and the lever on the side of the same, replace the
battery observing the correct polarity (Fig. 4)
Fig. 3 Fig. 4