UNPACKING TTHE A
APPLIANCE
Stand the carton right way up, cut the strapping bands and remove the top end cap. Read all the instructions
before continuing to unpack or install this appliance.
Remove the box containing the fire front, and the bags and boxes containing the ceramic parts. Remove the card-
board packing pieces, and any bags containing other fittings or parts. When all loose parts have been removed,
the outer sleeve may be lifted off to reveal the appliance. Check that the components supplied correlate with the
checklist given in section 7.1. Please dispose of the packaging materials at your local recycling centre.
COMPONENT C
CHECKLIST
QUA
ANTITY
DESCRIPTION
1
Firebox and burner tray assembly.
1
Decorative frame, one of several finishes.
1
Fire front with separate ashpan cover, one of several designs and finishes.
1
Moulded ceramic fibre combustion matrix.
22
Individual ceramic coals (coal effect option only)
22
Individual ceramic pebbles (pebble effect option only)
2
Moulded ceramic front coal strip (coal effect option only)
2
Moulded ceramic front strip (pebble effect option only)
3
Ceramic radiant panels.
1
Set of manufacturers instructions and warranty card.
1
Cable fixing kit comprising; 2 cables, 2 tensioners, 2 clamps, 4 fixing eyes, 4 fibre rawl plugs.
2
Ceramic brick panel retaining clips
1
Remote control handset (remote control option only)
1
Pack of batteries (1 x ‘PP3’, 4 x ‘AA’) (remote control option only)
1
Self tapping screw pack
3
Lengths of self adhesive sealing strip.
1
Rubber grommet.
PREPARING TTHE A
APPLIANCE
Note: EEnssure tthat tthe ggass ssupply iiss iissolated bbefore ccom-
menccingg iinsstallation oof tthe aappliancce.
The fireplace opening and environment must be in com-
pliance with the specifications laid down in the
appropriate sections of these instructions.
Remove the appliance from it’s carton as described pre-
viously and stand upon a dust sheet or similar. Place the
decorative frame, firefront, ceramics and fixings safely to
one side. Remove the burner from the assembly by
releasing the two screws through the tray legs. The tray
is now free, and may be lifted away.
The three radiant panels may now be fixed inside the firebox. Select the textured side
of each panel and insert as follows; Lay the firebox on it’s back. Lay the large rectan-
gular panel onto the rear face of the firebox. The side panels should be fitted by inserting their front edges into
the pre-fitted retaining brackets on the front face of the firebox. Gently align the side panels with the side of the
firebox, over the top of the back panel already in place. Make sure that the side panels are pushed up firmly to
the roof of the firebox, and bacck firmly to retain the back panel. Make small adjustments to line up the mortar
lines if required (brick patterned pads only). Secure the side panels using the small ‘Z’ shaped brackets and screws
provided. The screws should locate into the pre-punched holes in the sides of the firebox.
5
7.0
7.1
8.0
