Operating manual BMGZ 600A
29
is reached (parameter
Pre detect charge
), the silo will be shut automatically.
The conveyor belt is still running.
If the charge is completely weighed (parameter
Ref. charge 1
), the conveyor
belt stops automatically.
With the „stop“ key, the silo can be shut and the conveyor belt can be stopped
at any time.
7.8
Operating the Printer (optional)
Manual printing of charge protocol
The actual charge values may be printed out on a printer for protocol purposes.
Printing is started by pressing the
Mode
key in with
Special functions
Mode
according to fig. 25 (for measuring roller 1 or measuring roller 2). After printing the
charge protocol, the charge number is incremented. The charge value has to be
reset to zero by pressing the
CLR
key for 3 seconds.
The printing can also be started by applying 24VDC to the digital inputs
Prt1
(terminal 315) or.
Prt2
(terminal 318).
Automatic printing of charge protocol (BMGZ611A)
If the parameters
Ref. charge 1
contain values higher than zero, the procedure
described under „manual printing of charge protocol“ will be started at each time
the digital input „charge active“ (terminal 317) is reset.
Protocol printer
To drive the protocol printer, the parameter
RS232-Mode
must be set to „Protocol
printer“.
fig. 25: State diagram overview level
B600023e
