Operating Manual BKS309.W.M
22.02.2019
6
4
Installation and Wiring
Caution
Proper function of the controller is only guaranteed with the recommended
arrangement of the components. Other arrangements can cause heavy
malfunctions. Therefore, the installation instructions on the following pages must
strictly be followed.
4.1
Installation of the steering frame – FMS webMASTER
The mounting orientation of the steering frame (indicated by an arrow), must
correspond with the direction of the moving web. The lower frame part is mounted
with four M8 screws to the machine frame. The machine must be prepared to
accept the M8 mounting screws. The steering frame must be electrically grounded.
Connect the grounding bolt of the steering frame with a corresponding point of the
machine. Use appropriate grounding cable for this connection.
Definition of the sensor alignment and designation of orientation in this manual
The sensors need to be mounted on the discharge side of the steering frame. "Left"
and "right" always refers to the moving direction of the web.
1
Entry side
5
Sensor axis left
2
Exit side
6
Web edge left
3
Moving direction of the web
7
Web edge right
4
Sensor axis left
8
Sensor axis right
Illustration 2: Sensor alignment
Note
Make sure that the sensor(s) are connected properly to the electronic unit by