www.fmiproducts.com
56131L
26
straight twig which is placed across top
of logs “B”.
5. Figure 47 shows the top view of burner
and grate.
6. Place logs “A” as shown in Figure 48.
7. Place logs “B” as shown in Figure 49. Lift
end of log “A” that will be propped up and
place log “B” under it. At the same time,
the other side of log “B” is placed over the
other log “A”. Repeat procedure for the
other log “B”.The charred area on these
four interlocking logs must be aligned
flush with each other. Make sure the logs
does not cover any of the burner ports.
8. Take twigs “C” (shaped like a “Y”) and
place them as shown in Figure 50.
9. Take twigs “D” (bent twig) and place them
as shown in Figure 50.
10. Place twig “E” across top of logs “B” a
shown in Figure 50.
11. When finished installing logs, close glass
door. Make certain safety door switch is
fully pressed by door frame before secur-
ing four (4) spring loaded latches.
12. Replace louvers in reverse order with
grilles pointing in the down position.
WARNING: Improper installa
-
tion, adjustment, alteration, ser
-
vice, or maintenance can cause
injury or property damage. Refer
to this manual. For assistance or
additional information, consult
a qualified installer, service
agency, or gas supplier.
Open
Close
Figure 45 - Opening Door Latches
Figure 46 - Log Set (9 Pieces)
A
A
B
B
C
C
D
D
E
Left
Front
Right
Back
Figure 47 - Burner and Grate (Top View)
Left
Right
Back
Front
Figure 48 - Installing Logs “A” (Top View)
Left
Front
Right
Back
B
B
A
A
Figure 49 - Installing Logs “B ” (Top View)
Left
Right
Back
Front
D
C
C
D
E
Figure 50 - Installing Twigs “C, D, E ”
(Top View)
FIREPLACE
INSTALLATION
Continued
