www.fmiproducts.com
112127-01C
24
instaLLation
Continued
INSTALLING LOGS, LAVA ROCK,
AND GLOWING EMBERS
WARNING: Failure to posi
-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically ap
-
proved with this burner system
may result in property damage
or personal injury.
It is very important to install these logs ex-
actly as instructed in Figures 39 through 43.
Do not modify logs. Only use logs supplied
with freestanding burner system. Do not use
if any log(s) are broken (see
Replacement
Parts
, page 35).
1. Remove glass door. See
Removing/Re-
placing Glass Door,
page 23.
2. Place log #1 (back log) on top of grate.
Make sure notches in the bottom of log fit
over the grate (see Figure 39).
3. Rest log #2 (large front log) on the pins on
the front part of grate (see Figure 40).
4. Place log #3 (crossover log) onto rear and
front logs. Make sure it is seated properly
into notch on front log and over the raised
triangular portion of rear log as shown in
Figure 41, page 25.
Figure 39 - Installing Log No. 1
1
Figure 40 - Installing Log No. 2
2
5. Place log #4 (small log) onto front left part
of grate making sure the notches fits over
the prong of the grate. See Figure 42,
page 25.
6. Lava rock may be placed along sides
and front inside burner system bottom.
This may not be visible when you have
replaced the front of stove. It is not neces-
sary to use all of the lava rock provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
