RPM4-AD™ OPERATION AND MAINTENANCE MANUAL
© 2005-2007 DH Instruments, a Fluke Company
Page 112
4.6
IEEE STD. 488.2 COMMON AND STATUS PROGRAM
MESSAGES
The RPM4-AD supports a set of commands that are common to all instruments conforming to IEEE Std. 488.2.
These commands make it easy to perform basic function for any device that supports these commands.
These commands also cover the status reporting commands. See Section 4.1 for details on the status
registers mentioned in these commands.
Table 27.
IEEE-488.2 common and status program message list
∗
CLS
Clear all of the status & event structures.
∗
ESE
Read or set the Standard Event Status Enable Register.
∗
ESR
Read the Standard Event Status Register.
∗
IDN
Identify the RPM4-AD version, range, and serial number.
∗
OPC
Set the operation complete bit when all operations have completed.
∗
OPT
Read the list of installed RPM4-AD options.
∗
RST
Reset the RPM4-AD settings to factory settings.
∗
TST
Read the power on self test status.
∗
SRE
Read or set the Service Request Enable Register.
∗
STB
Read the Status Byte Register.
∗
RSE
Read or set the Ready Status Enable Register.
∗
RSR
Read the Ready Status Register.
4.6.1
PROGRAM MESSAGE DESCRIPTIONS
∗
CLS
Purpose
Clear all of the status & event structures.
Command
“
∗
CLS”
Remarks
This program message clears the following events and status registers:
Standard Byte Register (STB)
Standard Event Status Register (ESR)
Error Queue
Pending OPC operations
Example
Sent:
Reply:
“
∗
CLS”
none
∗
ESE
Purpose
Read or set the Standard Event Status Enable Register.
Command
Query
“
∗
ESE
n
”
“
∗
ESE?”
Default
“
∗
ESE 0”
Arguments
n:
’0 to 255’ This is the decimal representation of the bit(s) to enable. To enable
the PON and QYE bits, the argument would be 128 + 4 = 132.
Remarks
The Standard Event Status Enable register determines which bits in the standard Event
Status Register are enabled and included in the Status Byte Register (ESB bit), and can
assert the SRQ line. The reply is in decimal numeric form.
Example
(enhanced)
Sent:
Query reply:
“
∗
ESE=128”(enables the PON bit)
“128” (no reply if IEEE-488)
Errors ERR#
6:
n
is not valid.
∗
ESR
Purpose
Read the Standard Event Register.
Command
“
∗
ESR?”
Remarks
The Standard Event Register contents are cleared after reading. The reply is in decimal
numeric form.
Example
(enhanced)
Sent:
Reply:
“
∗
ESR?”
“20” (the QYE and EXE bits are set)
