Fluke endurance series, User Manual

Page: 84 / 102

Endurance® Series
Users Manual
72
9.1.10. 12-socket DIN Cable connector (E-2CCON) for multi-conductor cable
The 12-socket DIN Cable connector is a spare connector to replace a damaged one. In case
of shortening the existing multi-conductor cable, you can assemble the spare connector by your
own experienced technician. Please see in chapter 5.5.1.1, M16 12-Pin DIN Connector Signal
Assignment for detailed information.
Figure 52: 12-socket DIN Cable connector (E-2CCON) for multi-conductor cable
9.1.11. USB to RS232/422/485 converter (E-USB485)
The USB to RS232/422/485 converter (E-USB485) is for the direct adaptation of an Endurance
®
series device to a standard PC via the USB-interface. The converter supports auto configuration
in data format, baud rate and RS485 data flow direction control. It is able to automatical
configure RS-232, RS-422 or RS-485 signals to baud rate without external switch setting.
Furthermore, the converter is equipped with 3000V DC of isolation and internal surge-protection
on each data lines to protect the host computer and converter against high voltage spikes, as
well as ground potential difference. Please see under section 5.5.5, Computer Interfacing via
RS485 link for detailed system interfacing.
Specifications:

USB interface: Fully compliant with V1.0, 2.0 specification.

USB to serial bridge controller; Prolific PL2303HX.

RS-232 signal: 5 full-duplex (TXD, RXD, CTS, RTS, GND).

RS-422 signal: Differential 4 full-duplex wires (TX+, RX+, TX-, RX-).

RS-485 signal: Differential 2 half-duplex wires (D+, D-).

Data Format: Asynchronous data with all common combination of bits, parity, stop.

Parity type: None, odd, even mark, space.

Data bit: 5, 6, 7, 8.

Stop bits: 1, 1.5, 2.

Cable: USB type A to type B.

Communication speed: form 300bps to 256Kbps.

RS-422/485 line protection: Against surge, short circuit, and voltage peak.

Transmission distance: RS422/485 Up to 4000ft (1200M).

Connection type: Screw terminal accepts AWG #12~30 wires.

Signal LED: Power on, TX, RX.

Direct power from USB port.

Power consumption: 1.2W.

Isolation voltage: 3000V DC.

Operating environment: 0 to 60
℃
.

Storage temperature: -20 to 70
℃
.

Humidity: 10-90% non-condensing.

Dimension: 151mm X 75mm X 26mm.

Weight: 375g.
Figure 53: USB to RS232/422/485 converter (E-USB485)