Fluke endurance series, User Manual

Page: 35 / 102

Innovative High Temperature Fiber Optic Infrared Pyrometers
Installation
23
5. Installation
5.1. Mounting the Sensor
After all preparations are complete according to section 4 Sensor Location, page 19 ff., you can
install the sensor.
How and where to anchor the optical head and electronics enclosure depends on the type of
surface and the type of bracket you are using. You can mount the optical head through a hole,
on a bracket of your own design, or on the available adjustable bracket accessory.
You may need to ''snake'' the fiber optic cable through and around any obstacles, such as
beams, walls, support columns, etc., or, if your installation requires, through conduit, before
attaching the end to the electronics enclosure. (Do not attach until you aim the optical head.)
The cable can be disconnected from the electronics box for aiming or threading through conduit
during installation. The cable is keyed and can only be inserted one way into the electronics
enclosure.
Figure 9: Connecting the Fiber Optic Cable
Tighten only after securing connecting sleeve
Note keyed connecting sleeve
(can be inserted only one way
~slot must face mode switches
)
Push connecting sleeve in until it stops
(approx. 15 mm / 0.6 in)
Tighten screw (finger tighten only)