Fluke 9000A-Z80QT, Instruction Manual

Page: 15 / 108

ZBOQT
Section
2
Installation
2-1.
INSTALLING
THE ZBOOT DATABASE
(9100 SERIES
ONLY)
The Z80QT database for the 9100—Series
mainframe
is
contained on one 3.5-inch
floppy
disk supplied with the 9000A-Z80QT Pod.
To
install
the
database
on a mainframe with
a
hard drive, insert the disk into the
mainframe floppy
drive. Press MAIN MENU on the keypad, press SOFT
KEYS, then select COPY
DISK FROM DRl TO HDR.
and press ENTER.
The
database
only needs
to be installed once. Once the
database
is
installed on
the mainframe, place the original floppy disk in a safe place in case it
is
needed.
To
use the
database
on
a
mainframe with two
floppy drives, first copy the
database disk to
a backup disk using the mainframe
COPqunction.
Remove
the original from the floppy drive and insert the copy
into
the system
USERDISK.
Each time the mainframe is
reset, the
database
is read from the
floppy
disk. Place the original floppy disk in a safe place in case it
is
needed.
2-2. MAKING CONNECTIONS
Before a 9000 Series or 9100
Series tester (mainframe) can be used
to
perform a
test or
isolate a fault, it must be connected to the UUT.
Connection
is made
by
means of the pod, which
is equipped with two cable assemblies, one shielded-type
and one ribbon-type. Procedures for installing and connecting the pod are given
next.
Before making any connections to the UUT, read the following precautions:
WARNING
TO PREVENT POSSIBLE HAZARDSTO THE OPERATOR OR DAMAGE
TO THE UUT, DISCONNECT
ALL
HIGH-VOLTAGEPOWER SUPPLIES,
THERMAL ELEMENTS, MOTORS, OR MECHANICAL ACTUATORS
WHICH ARE CONTROLLED OR PROGRAMMED
BY
THE UUT MICRO-
PROCESSOR BEFORE CONNECTING POD.