Fluke 5790A, Operator'S Manual

Page: 136 / 220

5790A
Operators Manual
6-30
data permanently. The CALIBRATION STORE switch must be set to ENABLE and the
CALIBRATION MODE switch must be set to SERVICE to replace ALL or CAL data or
an execution error occurs.
Parameter
•
ALL (Replaces the whole contents with defaults)
•
CAL (Replaces all cal constants with defaults)
•
SETUP (Replaces setup parameters with defaults)
HIRES
Enables or disables higher resolution amplitude displays and remote responses as defined
in Table 4-5.
Parameter
ON or non-zero, or OFF or 0
HIRES?
Returns the setting of the HIRES command for higher resolution amplitude displays and
remote responses as defined in Table 4-5.
Response
(Integer) 1 for on, or 0 for off
INPUT
Selects the active input connector.
Parameter
INPUT1, INPUT2, SHUNT, WBND
INPUT?
Returns the name of the active input connector.
Parameters
None
Response
(CRD) INPUT1, INPUT2, SHUNT, or WBND
ISCE0
Loads two bytes into the Instrument Status 1 to 0 Change Enable register described under
"Checking 5790A Status."
Parameter
The decimal equivalent of the binary number to load into the register. You can also send
a binary, octal, or hexadecimal number if you precede the number with #b, #o, or #h,
respectively. (A number without a preceding designator is taken as decimal.)