Initial Setup and Configuration
Connect to Mains Power
2
2-3
Connect to Mains Power
Use the mains power cord to connect the Product to a 100 V ac, 120 V ac, or 230 V ac
nominal outlet as shown in Figure 2-2.
WX
Warning
To prevent possible electrical shock, fire, or personal injury:
•
Use only the mains power cord and connector approved for
the voltage and plug configuration in your country and rated
for the Product.
•
Replace the mains power cord if the insulation is damaged
or if the insulation shows signs of wear.
•
Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.
•
Do not put the Product where access to the mains power
cord is blocked.
W
Caution
To prevent damage to the Product, make sure the regional
voltage selector is in the correct position for the region of use
before mains power is connected.
hcn
0
51.eps
Figure 2-2. Mains Power Cord Connection
1.888.475.5235
Fluke-Direct
.com
