Fluke Calibration 4322-SYS-NAVAIR, Service Manual

Page: 46 / 186

4322
Service Manual
3-4
Required Equipment
The equipment in Table 3-1 is required to complete the calibration procedure.
Table 3-1. Calibration Equipment
Primary Reference
Classifications Minimum Use Specifications Suggested Equipment
Automated Pressure
Calibrator (APC) See Required Components Supplied with Fluke 4322
Pressure Controller
Range: 0.5 psia to 10,000 psia
(-14.2 to 10,000 psig)
Fluke 4322 required
Supplied with Fluke 4322
CPS module
(Contamination
Prevention System) Clean and dry. Supplied with Fluke 4322
Cylinder hose 10,000 psi, Fluke 4322 QC stem Supplied with Fluke 4322
Intensifier outlet hose 10,000 psi, Fluke 4322 QC stem Supplied with Fluke 4322
Test hose 10,000 psi, Fluke 4322 QC stem, King
Nutronics QC stem Supplied with Fluke 4322
Reference pressure
standard Gauge pressure:
0 to 4 psig: ±0.001 psi
4 to 10,000 psig: ±0.025 % of reading
Vacuum Pressure:
0 to 30 inHg: ±0.025 % of reading or
±0.002 in-Hg, whichever is greater
Absolute Pressure:
0.5 to 35 inHga: ±0.002 inHg
17.2 to 10,000 psia: ±0.025 % of reading
King Nutronics 3689 or
equivalent
Nitrogen Supply Clean, dry, minimum 500 psig Nitrogen Cylinder
IEEE cable Standard: IEEE-488.2
Minimum length: 2 ft Supplied with Fluke 4322
Environmental Conditions
Laboratory environmental conditions required to complete this procedure:
•
Ambient temperature range: 60 °F to 85 °F. Must not change more than ± 4 °F
throughout the calibration.
•
Ambient relative humidity: 5 % to 95 %. Must not change more than ±20 % RH
throughout the calibration.
•
Low wind and draft area.