FLORABEST 79737, Instructions For Use Manual

Page: 7 / 24

7 GB/IE
Selecting the location
• The article has a dimension of 3x3m, and
further requires space for the guy lines.
• If possible, set the product up in a location
protected from wind.
• In light winds be sure the open sides of the
pavilion are on the lee side.
• The ground should be level and tent pegs
should provide adequate stability.
Assembly
Parts descriptions (Fig. A)
1 – Pavilion roof
2 – Corner joint
3 – Tent peg
4 – Base plate
5 – Guy line
6 – Corner tarp
7 – Hook for corner tarp
8 – V-tent pegs
9 – Side wall without window
10 – Extending foot
11 – Side wall with window
12 – Side wall and roof hook and loop fasteners
13 – Loop for guy line
14 – Crossbars
15 – Corner bars / telescoping bars
16 – Roof bars
note! Product assembly requires at
least 2 persons. We recommend assem-
bly with 4 persons.
Step 1
Remove the article from the storage bag.
Step 2
Slowly and evenly extend the article at the
opposite corners (Fig. B and C).
Step 3
Slide the corner joints (2) for each corner as far
up until the locking pin on the corner poles locks
in (Fig. D).
note! great resistance indicates the
article is not yet extended far enough.
Attention! Pinching hazard at the corner
joint!
Step 4
Extend the telescoping feet (10) in the corner
poles. To do so, place one foot onto the base
plate (4) of the feet and slide the upper part of
the corner pole up until you hear the telescoping
foot lock in (Fig. E).
note! you may choose from 3 height
settings.
Step 5
Tighten the corner tarps (6) by securing the
factory installed hooks (7) in the designated
opening on the telescoping foot (Fig. F).
There are 3 openings to choose from:
When the telescoping foot is locked into the lo-
west position, also secure the hook in the lowest
position.
When securing the telescoping foot in the middle
or top position, also select the respective middle
or top opening.
Step 6
Anchor each telescoping foot using the included
tent pegs (3) using the openings in the base
plate (Fig. G).
Caution! verify the tent pegs are firmly
secured.
Step 7
Knot one guy line (5) into each loop (13) on the
outside corners of the article (Fig. G).
Tauten the lines and secure the ends with the
V-tent pegs (8) (Fig. G).
Caution! Again be sure the tent pegs
are securely anchored.
Step 8
Secure the side walls (9, 11) to the pavilion cor-
ner poles / telescoping poles (15) and crossbars
(14) using the factory installed hook and loop
fasteners (12) (Fig. H).
note! When fastening be sure the
wrapped seam on the edges of the
side walls faces inward.
Step 9
Secure the factory installed hook and loop
fasteners to the roof bars (16) (Fig. I).