FLYING STABILIZER INSTALLATION
To reduce the assembly time of your FlexJet TV, the stabilizer tubes have been installed at the factory.
Confirm that (1) M3x10mm Phillips head machine screw is securely fastened to each stabilizer tube.
Do not overtighten.
Power on the radio system. Ensure the elevator servo arm is installed on the correct spline. The servo arm should be perpendicular
relative to the servo case and pointing toward the bottom of the fuselage.
Cut out the
elevator trim gauges
located on the rear cover of the manual. Align the center-line of the elevator trim guage with the
panel line just forward of the flying stabilizers. Tape the elevator trim gauges onto the fuselage using low-tack masking tape.
Power on the transmitter and aircraft, once powered, insert a stabilizer into the fuselage.
1.
2.
3.
4.
Required Tools and Fasteners:
#1 Phillips Screwdriver, 2mm Hex Driver
Blue Thread Locker, Low-Tack Masking Tape
(2) M3x10mm Phillips Machine Thread Screw
(factory-installed)
(2) M2 x 6mm Cap Head Self-Tapping Screws
12