3
Place the drilling template on the front service panel
under the draw spout so that the folded edge is placed
along the service panel edge. Tape the template in place
or mark the hole to be drilled in front service panel.
6
Install the door and spout asembly onto the freezer.
5
Install the valve, spring and cap to the door spout
assmbly. Then install the assembly onto the freezer door.
4
Install the panel mount connector on the panel, inserting
the connector line through the hole. Secure the
connector from the inside of the panel with the nut
provided.
8
7
Remove the panel and drill the 7/16” hole where marked.
Deburr the hole if necessary.
ADPT TY80S-FCB2 FCB Auto Draw Valve Conversion Kit
REV021313
pg. 2 of 6
Install the Cylinder Assembly on the modified door spout
by sliding the bracket over the threaded portion of the
door spout. Install the draw handle pin assembly from the
kit onto the Cylinder Assembly and tighten screw to
secure.
