Power Supply
Cable Harness
Notch
EPROM
Loosen the two bottom hand knobs slightly on the door.
Install the Draw Switch Housing over the Cylinder
Assembly on the draw spout. Tighten the hand knobs to
secure.
22
Install the new INJ 201A manifold into the 9-Tube coupler
assembly.
21
Remove the back cover of the Flavor Burst cabinet and
locate the sanitizer pump near the base.
26
25
Remove the cabinet cap and replace the E-prom near the
back with the E-prom provided in the kit. Be sure to
disconnect and reconnect the Power Supply Cable
Harness when removing and installing the cap.
Plug the keypad stereo plug into the Switch Housing.
24
23
Connect the Cylinder Assembly line to the panel mount
connector. Insert the 9-Tube Assembly into the syrup port
on the modified draw spout. Rotate the 9-Tube Assembly
until motion stops to secure.
ADPT TY80S-FCB2 FCB Auto Draw Valve Conversion Kit
REV021313
pg. 5 of 6
