NOTE:
PRODUCT WILL DISPENSE APPROXIMATELY 1-2 SECONDS
AFTER THE BUTTON IS RELEASED TO CLEAR THE SPOUT OF
FLAVORED PRODUCT. THIS PROCESS PURGES THE SPOUT OF LEFTOVER
FLAVOR AND REDUCES FLAVOR CARRYOVER TO THE NEXT SERVING.
Install the kit’s push-to-connect elbow connector to the
Pump Flush Tube and the sanitizer tank tube.
28
Disconnect and remove the push-to-connect tee
connector from the two elbow connectors and the Pump
Flush Tube.
27
To adjust syrup flow, remove the Housing from the
Cylinder Assembly. Tighten the flow rate screw
(clockwise) to decrease the product flow and increase
flavor output. Loosen the screw (counter-clockwise) to
increase the product flow and decrease flavor output.
32
31
To clear out the spout and ensure everything is working
properly, draw a serving. Place a cup beneath the spout.
Select flavor(s) from the keypad. Press and hold button to
dispense. When the cup is nearly full, release the button
and wait for the freezer to finish dispensing.
Fill the freezer hopper with FCB product. While product is
freezing down, follow instructions in the Operations
Manual to prime the syrup pumps and lines.
30
29
Install the cabinet cover back onto the Flavor Burst
Cabinet.
ADPT TY80S-FCB2 FCB Auto Draw Valve Conversion Kit
REV021313
pg. 6 of 6
