Installation instruction
FläktGroup
DC_8658GB 20181214_R0
We reserve the right to make changes without prior notice
15
GENERAL INSTRUCTIONS
SUPPORTING FRAME FOR OVERHANGNING
UNIT PARTS
Unit configurations where the upper block overhang the lower
block needs to be supported and secured.
The accessory EQAZ-11 (Supporting frame), is used for this
purpose as shown in the picture below.
In cases where EQAZ-11 hasn’t been ordered, it is the responsi-
bility of the installer to properly support and secure the unit.
FläktGroup does not take responsibility for any injuries or
damages that may occur when other equipment than EQAZ-11 is
used to support overhanging block parts.
VERTICAL MOUNTING. THE UNIT MUST BE ORDERED
FOR VERTICAL INSTALLATION.
UNIT SIZES 005-009 (SINGLE DECK CASING), 005-008
(DOUBLE DECK CASING)
The following supporting surface is required for a vertical
arrangement:
Flat floor or frame made of angle steel, for example 50 x 50 x 5
with outer dimensions adapted to the outer dimensions A x B of
the air handling unit.
MOUNTING ON A WALL STAND
MOUNTING ON A FLOOR STAND
Warning!
The unit should be secured in a professional
manner.
Contact FläktGroup for consultation if
needed. Overhanging and unsecured block
parts can lead to personal injuries and
material damages.
N.B !
Vertical installation can be employed only for
unite sizes 005–009 in single deck casing and
for unit sizes 005-008 double deck casing.
Important!
The stand must not be designed in such a
manner that the inlet or outlet or the inspection
doors are obstructed.
Anchoring the unit to a wall can appropriately
be done with clamps or anchor brackets, such
as perforated strips.
EQAZ-11
EUGA 18
EUGA 17
EQAZ-63 for
unit sizez
005-008
