11
ASSEMBLY
Flywheel
Step 2
2a. Rotation Rod Lubrication:
Use the
6mm Allen Wrench with Phillips Screwdriver
provided
to remove the following PRE-ASSEMBLED hardware from both ends of the
Rotation Rod (60)
: two
Bolts (5)
, two
Spring Washers (6)
, two
Washers (7)
, and two
Wave Washers (22)
. Put the
removed hardware to the side. Lubricate the
Rotation Rod (60)
with some of the
Grease
provided.
2b. Rotation Rod Reassembly and Handrail Installation:
Insert the
Rotation Rod (60)
into the
tube on top of the
Mainframe (59)
, located above the
Flywheel (49)
and place a
Wave Washer (22)
on each end. Attach the
Right Handrail (9)
onto one end of the
Rotation Rod (60)
and secure it in
place with one
Bolt (5)
, one
Spring Washer (6)
, one
Washer (7)
.
Do not tighten any bolts until
both handrails are attached
. Repeat the steps above for the attachment of the
Left Handrail (77)
to the other end of the
Rotation Rod (60)
.
2c. Rotation Rod Tightening:
After both handrails have been attached, tighten the handrails using
the
6mm Allen Wrench with Phillips Screwdriver
provided to simultaneously secure in both
Bolts (5)
at the two ends of the rotation rod until they are firm.
6mm Allen Wrench with
Phillips Screwdriver
Tool
Summary of Contents for AIR ELLIPTICAL
Page 5: ...3 LABEL PLACEMENTS ...
Page 8: ...6 OVERVIEW DRAWING ...
Page 11: ...9 HARDWARE TOOLS PACK ...
