15
ASSEMBLY
!
L for left bolt
Important:
Installing left bolt into left
crank can only be done
by turning left
(COUNTER-CLOCKWISE).
75
76
Step 5
5a. Foot Pedal Support Bracket Installation:
Attach the
Foot Pedal Support Bracket
(18)
onto
the right side of the
Left Foot Bar (76)
using two
Bolts (23)
, two
Washers (24)
, and two
Nylon
Nuts (25)
. Simultaneously use the
Flat Wrench
and the
6mm Allen Wrench
provided to tighten
the nuts and bolts.
5b. Left Crank Bolt Lubrication and Alignment
: Lubricate the
Left Crank Bolt (64)
with some of
the
Grease
provided. Insert the
Left Crank Bolt (64)
and one
Wave Washer (22)
through the right
holes of the
Left Foot Bar (76)
. Raise the rear end of the
Left
Foot Bar (76)
and align it with the
threaded hold of the
Left Crank (75)
.
5c. Left Crank Bolt Installation
: Make sure the
Left Crank Bolt
(64)
is perfectly level and straight
as you insert it through the aligned hole of the
Left Crank (75)
. Turn the
Left Crank Bolt (64)
counter-clockwise
by hand until it is firm. After the initial hand tightening, use the
8mm Allen
Wrench
provided to tighten the bolt until firm. Put one
Spring Washer (27)
and one
Left Nylon
Nut (87)
onto the threaded end of the
Left Crank Bolt (64)
. Simultaneously use the
Flat Wrench
on the
Left Nylon Nut (87)
and the
8mm Allen Wrench
on the
Left Crank Bolt (64)
to tighten the
Left Nylon Nut (87).
Cover the
Left
Nylon Nut (87)
with one
Cap Nut (97)
.
Read to
Figure F
note on next page regarding tightening guidelines. Refer to the illustration
showing the correct installation of the
Left Crank Bolt (64).
Tools
Flat Wrench
8mm Allen Wrench
Summary of Contents for AIR ELLIPTICAL
Page 5: ...3 LABEL PLACEMENTS ...
Page 8: ...6 OVERVIEW DRAWING ...
Page 11: ...9 HARDWARE TOOLS PACK ...