24
ASSEMBLY
Step 13
13a. Computer Console Installation:
Connect the
Extension Sensor Wire (10)
coming out from
the top side of the
Hand Pulse Handlebar Support Frame (41)
to the male connector wire coming
out from under the
Computer Console (29)
. Make sure
the connectors “click” when connected.
Connect the two
Hand Pulse Sensor Wires (35)
coming out from the
Hand Pulse Handlebar (33)
to the two female connectors coming out from the
Computer Console (29)
. Make sure the
connectors “click” when connected. Firmly slide the back of the
Computer Console (29)
onto the
Tab
located on the top of the
Hand Pulse Handlebar (33)
.
Refer to
Figure H
and the illustration
above.
13b. Adjustable Leveler Installation
: Remove the
Nut (58)
from the
Adjustable Leveler (57)
. Put
the nut aside. Screw the
Adjustable Leveler (57)
upwards into the bottom right u-shaped bracket
of the
Mainframe (59)
and place the removed
Nut (58)
back onto the
Adjustable Leveler (57)
.
Hand-tighten the
Adjustable Leveler (57)
to secure the
Nut (58)
until it is firm and secure. Repeat
the previous steps to install the
Adjustable Leveler (57)
on the left side.
IMPORTANT:
To prevent the elliptical from wobbling during a workout, make sure you adjust the
levelers as instructed in the adjustments section.
(57) Adjustable Leveler
2PCS
(58) Nut
2PCS
HARDWARE
Figure H
Summary of Contents for AIR ELLIPTICAL
Page 5: ...3 LABEL PLACEMENTS ...
Page 8: ...6 OVERVIEW DRAWING ...
Page 11: ...9 HARDWARE TOOLS PACK ...
