- 58 -
Re-assembly
(a)
Re-fit in reverse manner.
(b)
Follow re-assembly procedure. (Refer to Section 7.5).
For lower cavity in double ovens
Removal
(a)
Follow general servicing instructions for components in back panel area. (Refer to
Section 7.3)
(b)
Remove exhaust fan retaining screw.
(c)
Remove lower section of vent ducting.
(d)
Remove exhaust fan wiring and transfer to replacement fan.
(e)
Pull exhaust fan off vent tube.
Re-assembly
(a)
Re-fit in reverse manner.
(b)
Follow re-assembly procedure. (Refer to Section 7.5).
7.18
Oven Cavity Fan
Location:
Back panel area.
Removal
(a)
Follow general servicing instructions for components around back panel area.
(Refer to Section 7.3).
Note:
If the oven fan is not operating then check to see if the fan element is
operating properly as the element will burn out if it has no cooling air supply.
(b)
Remove oven fan shroud. (Refer to Section 7.20).
(c)
Remove oven fan blade in oven cavity.
Note:
Turn fan blade securing nut clockwise to remove (Left hand thread).
(d) Remove three screws securing to rear
insulation panel.
(e) Disconnect wires and transfer them to
replacement fan motor.
(f)
Remove fan motor from back panel.
(g)
Transfer the mounting plate to replacement
fan motor.
Note:
To remove mounting plate use pliers
to bend holding tabs back.
Re-assembly
(a)
Re-fit in reverse manner.
(b)
Follow re-assembly procedure. (Refer to Section 7.5).
