- 54 -
(d)
Disconnect wire connector in back panel area.
(e)
Pull the light assembly wires out through oven cavity until wire connectors are
accessible.
Note:
String can be tied on the end of the light assembly wires to aid in feeding
the wires back through the holes in the side insulation panel.
Re-assembly
(a)
Feed new wire connectors back through the holes in the side insulation panel.
(b)
Follow re-assembly procedure. (Refer to Section 7.5).
For Front Lamp Assembly
Removal
(a)
Follow general servicing instructions for components in control panel area. (Refer
to Section 7.2)
(b)
Remove lamp glass and bulb. (Refer to Section 7.13)
(c)
Remove two lamp assembly retaining screws.
(d)
Disconnect wires from terminal block in top panel area.
(e)
Remove 3 screws along front of wiring panel and 2 screws either side fixing wiring
panel.
(f)
Lift front of wiring panel to access lamp wires
(g)
Pull wires through hole in wiring panel and through wire looms.
Re-assembly
(a)
Feed new wire back through the hole in the wiring panel.
(b)
Follow re-assembly procedure. (Refer to Section 7.5).
Wiring Panel
Remove Screws
(5 OFF)
