11
2.
Connect the RJ12 female connector (provided with the EC485, IC485 or UC485 (preferred)) to
terminals TD(A), TD(B), RD(A) and RD(B) on the UC485. The pins on the RJ12 connector
should line up with the terminals on the converter.
3.
Plug one end of the ED512-2, -4 or -8 cable into the RJ12 jack on the UC485 and the other end
into either of the RJ12 jacks located on the underside of the YZ300 (YZ320) Interlock Annunci-
ator.
4.
The YZ300 (YZ320) must be powered and if not connected to the BurnerLogix, the default
address is set to 1 and the baud rate is 9600,N,8,1.
RUNNING THE YZ300P SOFTWARE
1.
Run the YZ300P software on the PC. After the introductory and obligatory splash screen, a list
of available COM ports will be displayed. Use the TAB and arrow keys or mouse to select the
proper port.
UC485 or equivalent
see UC-4851 for setup &
configuration.
ED512, connect to
either COMMS port
If the COMMS of the BurnerLogix and YZ300 (YZ320) are connected together, the
YZ300 (YZ320) assumes the address and baud rate of the BurnerLogix control. Check
PROGRAM SETUP sub-menu for the current settings.
