Use to set the Full Load Amps of the motor being used. Press to con
fi
rm.
Note: This is a factory setting and can only be modi
fi
ed by a quali
fi
ed service technician.
Use to set the value of the CT’s being used. Press to con
fi
rm.
Note: This is a factory setting and can only be modi
fi
ed by a quali
fi
ed service technician.
Use to set the amp value at which the motor overload alarm will activate. Press to con
fi
rm.
Note: Default setting is 150% of motor FLA.
Use to select required frequency (50 or 60 hz.). Press to con
fi
rm.
Note: This is a factory setting and can only be modi
fi
ed by a quali
fi
ed service technician.
DIGITAL SOFT START
The programmed motor FLA value is displayed. This setting cannot be changed from this location.
MOTOR FLA
INIT CURRENT
3
Use to set the Initial Starting Current (100-250% FLA). Press to con
fi
rm.
MAX CURRENT
3
Use to set the Maximum Starting Current (250-600% FLA). Press to con
fi
rm.
ACCEL RAMP
3
Use to set the Acceleration Ramp time (2 - 7 sec.). Press to con
fi
rm. This is the time allowed for the soft
starter to ramp from the initial starting current to the maximum starting current.
UTS TIMER
Value is shown for the UTS (Up To Speed) Timer. This timer determines how long to wait for the soft starter to reach
full speed before a fault is indicated.
DECEL BEGIN LEVEL
3
Use to set the Deceleration Begin Level (70-95% FLA). Press to con
fi
rm. The starter will reduce current to
set level at the beginning of the deceleration ramp.
DECEL PAUSE LEVEL
3
Use to set the Deceleration Pause Level (32-60% FLA). Press to con
fi
rm. The starter will reduce current to
set level at the beginning of the pause cycle (sincerity test).
DECEL PAUSE TIME
3
Use to set the Deceleration Pause Time (2 - 7 sec.). Press to con
fi
rm. The starter will pause and hold for
set time to ensure no starting causes are present.
DECEL END LEVEL
Soft starter will decel to 25% motor FLA before disconnecting power from the motor. This setting cannot be changed.
DECEL TIME
3
Use to set the Deceleration Ramp Time (2 - 7 sec.). Press to con
fi
rm. This is the time of the deceleration
ramp from begin level to end level (not including the decel pause time).
PHASE ROTATION
Controller phase rotation is shown. This setting cannot be changed from this location.
3
SETTINGS
MOTOR & POWER
FREQUENCY
3
SETTINGS
MOTOR & POWER
FULL LOAD
3
SETTINGS
MOTOR & POWER
CT RATIO
1
SETTINGS
MOTOR & POWER
OVERLOAD
SETTINGS
MOTOR & POWER
TIMEOUT ENABLED
This is a read only setting that is transmitted to the digital soft starter.
TIMEOUT
This is a read only setting that is transmitted to the digital soft starter.
1
Use to select required phase sequence (1~, abc, cba). Press to con
fi
rm.
Note: This setting is used to clear a false phase reversal alarm. On 3-phase systems, once proper motor rotation is con-
fi
rmed, if phase reversal alarm is present, change this setting to clear the alarm. (If set to abc, change to cba or vise-
versa). Single phase mode (1~) is only used for demo purposes or on rare limited service applications.
SETTINGS
MOTOR & POWER
PHASE SEQUENCE
15
