2 6
Finalizing the Installation
Travis Industries
9 3 5 0 8 1 0 3
1 5 1 0 0 2
1
Remove the glass (and arch covers) following the directions below.
Warning:
The appliance must be completely cool before removing the glass.
Note
:
If using an arch face, attach the arch covers after re-installing the glass.
Insert the included glass latch tool into
the hole on the glass frame latch.
a
b
c
Pull the latch out then up to detach it from
the glass frame.
Hold the glass in
place and repeat
steps "a" and "b"
for the opposite
side latch.
d
Hold the bottom of the
glass while swinging the
top outwards. At
approximately 45¡ the
glass, with frame, can be
pulled up and away. Set
the glass aside to prevent
damage.
Glass Replacement
Make sure both bottom latches are facing upwards
Position the glass at a 45¡ angle and lay it on
the two tabs below the firebox. When
correctly positioned, the tabs on the frame
should insert into the bottom latches.
Swing the glass into place (make sure
the bottom latches are engaged.
Re-attach the top latches (see steps
"a" and "b" above).
Arch Cover
Arch Faces:
Attach the arch covers before
attaching the face.
Rectangular Faces:
Discard the arch covers.
Glass
The arch covers (included in the owner's
pack) block light from exiting the scroll
work on arched faces. The covers hang
on the glass frame.
Glass
Frame
Arch Covers (both sides)
Front of Fireplace
Glass
Glass Frame
Glass
Frame
Latch
Glass Latch Tool
NOTE:
A hole is provided here
to store the glass latch
tool.
