Optional Equipment
(for qualified installers only)
3 9
Travis Industries
9 3 5 0 8 1 1 6
0 3 1 0 0 0
3
Follow the directions below to remove the natural gas orifices. Apply thread sealant to the LP orifices
and tighten them in place with a 1/2" open end wrench (make sure to install the orifices correctly – see
the illustration below). Slide the adjustable shutter back in place over the orifice.
1/2" Wrench
Use a 1/2” open end wrench to
unscrew the burner orifice.
NOTE:
Screw the LP orifice in
so the orifice shoulder
protrudes 5/16”
(indicating full insertion).
43
54
The new LP orifice
has “.054” stamped
on it.
The old NG
orifice has “43”
stamped on it.
Apply thread
sealant to the
new orifice and
install.
5/16”
Remove the four screws
holding the mixing tube in
place.
Remove the mixing tube
from the air shutter by
sliding it to the left.
1/4" Nutdriver
Air Shutter
a
b
Slide the air shutter to the fully
open position (see page 26).
Manifold
Burner Orifice
c
d
e
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
