12
FINAL SET UP
!!! WARNING !!!
Failure to position the parts in accordance with all included
pictures, diagrams, and drawings, or failure to use only parts
specifically approved with this heater may result in property
damage or personal injury.
DO NOT
USE ANY MATERIAL NOT FURNISHED WITH THIS
APPLIANCE!
1-
Lightly, spread the Glowing Embers over the lower section
of the burner ( the burner section closest to the front of the
fireplace ); very little is needed to cover the area, and the
use of too much, will retard the yellow flame, and eliminate
the glow. Apply just enough to obtain a slow glow.
DO NOT PLACE GLOWING EMBERS DIRECTLY ON
THE BURNER PORTS; THIS WILL CAUSE SOOTING!
( SEE FIGURE 21, 22, 23, 24, 25, & 26 )
FIGURE 21
FIGURE 22 – LEFT VIEW
FIGURE 23 – RIGHT VIEW
WARNING: Apply loose material, ( Embers & Lava Rock [ Cinders ] ) per instruction manual. DO NOT apply extra material not
supplied with this appliance.
WARNING: All previously applied loose material ( Embers ) must be removed prior to reapplication
CAUTION: DO NOT place Glowing Embers in the area of the safety pilot assembly!
SEE FIGURES 21, 22, 23, 24, 25, & 26
Summary of Contents for AF-1100 VALVE SERIES
Page 23: ...23 NOTES...
