Fimer TM 236, Instruction Manual

Page: 50 / 168

14
4.3 Pulse synergic MIG WELDING
Pulse synergic MIG welding allows obtaining
a relatively cold welding bead and good
penetration.
The low energy input makes this welding
process particularly suitable for thin layers
and for materials such as stainless steel and
aluminium.
During welding with synergic adjustment, the
wire speed (i.e. welding power) can be
adjusted with knob 9 shown in Fig.1.
The other parameters are automatically
adjusted to the set power depending on the
type and diameter of the wire selected.
By turning switch 10 it is possible to choose
from the different MIG-MAG welding modes;
press the switch to select the desired option.
Once selected, the screen with the welding
wire material options will appear:
Settings that do not appear on the screen
are accessible by turning switch 10.
Once the type of wire has been selected
(using switch 10), the settings page for the
welding wire diameter will appear.
The wire’s diameters could not be available
for all models.
Selecting this option will take you to the
welding screen:
Ready to weld
START
BACK
MEM +
OPTIONS
150
A
30,7
V
>
MIG-MAG
A.P.S.
Fe
0,8mm
arc lenght
deposit
double pulse
L1 span
L2 span
L2 amplitude
L2 arc length
2s-4s-4bilevel
2nd level
start/End level
Start level
Start level time
Ls->L1 slope
L1->Lf slope
End level
End level time
spot welding
pause
pre gas time
post gas time
burnback
soft-start
hot start
inductance
water pump
0,0v
0,0m/’
OFF
0,3s
0,3s
60%
0,0v
2t
80%
OFF
125%
0,0s
0,0s
0,0s
80%
0,0s
0,0s
0,0s
0,1 s
2,0 s
0,0
0
0
0
OFF
14,8m/'
5,0mm