FT-70/75 Fill Level Inspectors Operator’s Guide
4-6
Diagnostic Error Codes Descriptions
Error Number 2
An attempt was made to activate the rejector while the Rejector
Status Function is turned off. To correct this error, turn the Rejector
Status Function on. For more information see “Software Function
Descriptions” in Chapter 3.
Error Number 5
The maximum limit of 32 containers between the trigger beam and
the rejector has been exceeded. Report this error to your Service
Department.
Error Number 6
A consecutive reject timing error that occurs when an encoder
pulse is missed. One pulse per container is required, and starting
and stopping the conveyor suddenly while a container is in the
inspection trigger zone, or improper encoder calibration caused a
missed pulse. Report this error to your Service Department.
Error Number 10
This error occurs when the number of consecutively rejected
containers exceeds the limit set in the Consecutive Fill Level Reject
Alarm Function. Report this error to your Service Department.
Error Number 11
This error occurs when the number of consecutively rejected
containers exceeds the limit set in the Consecutive Missing Cap
Reject Alarm Function. Report this error to your Service
Department.
Error Number 12
This error occurs when the number of consecutively rejected
containers exceeds the limit set in the Consecutive High Cap Reject
Alarm Function. Report this error to your Service Department.
Error Number 13
This error indicates the x-ray counts detected by the scintillation
tube are 12% below the of the reject threshold level. Report this
error to your Service Department.
Industrial Dynamics Company, Ltd. Document 40274-0600
