
Chapter 2: Operating Your FT-70/75
Adjusting the Conveyor Guide Rails
To accommodate the new container you may need to adjust the
Conveyor Guide Rails. If this is required, your Service Department
should instruct you in the proper method.
Adjusting the Centerline Trigger Bracket Height
When you adjusted the head height for the new container, the
Centerline Trigger Bracket also moved because it is attached
directly to the Inspection Head. Therefore, you may need to adjust
the Trigger Bracket to accommodate the new container type.
Note
Your Service Department should indicate whether or not you will
need to make this adjustment and what the adjustment should be.
1.
Loosen the Centerline Trigger Bracket Height Lock. See Figure
2-3 on page 2-6.
2.
There is a Height Adjustment Scale located on the side of the
Inspection Tunnel that you will use to measure the height (see
Figure 2-3 on page 2-6). Your Service Department may have
marked the correct height for each container type on the scale.
If the correct height is not indicated, or you do not know the
correct height you will need to determine the correct setting:
•
For more information see “Aligning the Inspection Trigger
(Bottles)” on page 2-15.
•
For more information see “Aligning the Inspection Trigger
(Cans)” on page 2-22.
3.
Use the Centerline Trigger Bracket Height Adjustment Crank
to adjust the bracket height to the proper height.
4.
Tighten the Centerline Trigger Bracket Height Lock to secure
the position.
Industrial Dynamics Company, Ltd. Document 40274-0600
2-7