QuickServer Start-up Guide
Page 9 of 30
Connect to the 3 pins on the left-hand-side of the 6 pin connector as shown.
For connection to RS-232 or RS-422, please refer to Appendix A.2
Connect to the 3-pin connector as shown.
Connect the QuickServer to the LonWorks terminal using a twisted pair non-shielded cable.
LonWorks Service Pin
LonWorks Terminal
To commission the QuickServer LonWorks port, insert a small screwdriver in the commissioning hole on the face of
the QuickServer’s enclosure to access the Service Pin. See the instructions on the QuickServer as to which way to
toggle the screwdriver during commissioning.
4 . 2 Q u i c k S e r v e r L o n W o r k s – ( PS - QS - 1 0 11/1511 - XXXX)
+
-
GND
4 . 1 . 2 RS - 4 8 5 C o n n e c t i o n R 1 P o r t (O n l y o n N o n - L o n W o r k s Q u i c k S e r v e r s
B+ A- SG
4 . 1 . 1 RS - 485 C o n n e c t i o n R 2 p o r t
4 . 1 RS - 485
4
I N S T A L L I N G T H E Q U I C KS E R V E R
ProSoft Technology, Inc. is a provider of FieldServer QuickServers. For Technical Support call
+1 661.716.5100
