QuickServer Start-up Guide
Page 23 of 30
port of the QuickServer.
Lon port of the QuickServer.
For UL compliance, the following instructions must be met when operating the QuickServer.
The units shall be powered by listed LPS or Class 2 power supply suited to the expected operating
temperature range.
The interconnecting power connector and power cable shall:
Comply with local electrical code.
Be suited to the expected operating temperature range.
Meet the current and voltage rating for the QuickServer/Net
Furthermore, the interconnecting power cable shall:
Be of length not exceeding 3.05m (118.3”)
Appendix D.4. Compliance with UL Regulations
Driver
Code
BACnet/IP – BACnet MS/TP
0285
BACnet/IP – LonWorks
0131
JCI Metasys N2 – LonWorks
0097
JCI Metasys N2– BACnet MS/TP 0309
JCI Metasys N2– BACnet/IP
0122
Modbus RTU – BACnet MS/TP
0367
Modbus RTU – BACnet/IP
0104
Modbus RTU – JCI Metasys N2
0038
Modbus RTU – LonWorks
0085
Modbus TCP – BACnet/IP
0237
Modbus TCP – LonWorks
0154
Modbus TCP – BACnet MS/TP
0419
Modbus TCP – JCI Metasys N2
0117
SNMP – BACnet/IP
0333
SNMP – LonWorks
0337
SNMP – JCI Metasys N2
0150
Add BACnet MS/TP - LonWorks
0345
Appendix D.3. QuickServer PS-QS-101X DCC
Light
Description
LON-TX LED
On normal operation of PS-QS-1011/1511-XXXX, the TX LED will flash when a message is sent on the
Lon
LON-RX LED
On normal operation of PS-QS-1011/1511-XXXX, the RX LED will flash when a message is received
on the
LON-SRV
LED
(next to Lon
port)
The LON-SRV LED will flash if the PS-QS-1011/1511-XXXX is configured for implicit addressing and
not commissioned. LED will be off if the PS-QS-1011/1511-XXXX is configured for implicit
addressing and commissioned or if it is configured for explicit addressing.
LED 7
Not used
LED 8
Not used
ProSoft Technology, Inc. is a provider of FieldServer QuickServers. For Technical Support call
+1 661.716.5100
