QuickServer Start-up Guide
Page 21 of 30
LED’s
Light
Description
RTC
To Be Determined
RUN
RUN LED will flash 20 seconds after power up, signifying normal operation. The QuickServer will be able
to access FS-GUI (refer to Section
Error! Reference source not found.
for more information) once this
LED starts flashing. During the first 20 seconds, the LED should be off
ERR
The ERR LED will go on solid 15 seconds after power up. It will turn off after 5 seconds. A steady red light
will indicate there is a system error on the FieldServer. If this occurs, immediately report the related
“system error” shown in the error screen of the FS-GUI interface to FieldServer Technologies for
evaluation.
RX
On normal operation of PS-QS-1010, the RX LED will flash when a message is received on the field port of
the QuickServer.
TX
On normal operation of PS-QS-1010, the TX LED will flash when a message is sent on the field port of the
QuickServer
PWR
This is the power light and should show steady green at all times when the QuickServer is powered.
Appendix D.1.1. LED Functions
Appendix D.1. PS-QS-1010/1510-XXXX LED’s
Appendix D Reference
ProSoft Technology, Inc. is a provider of FieldServer QuickServers. For Technical Support call
+1 661.716.5100
