PA-2007 Mainboard Manual
16
If the serial port 1 uses the onboard I/O controller, you can modify your serial
port parameters. If an I/O card needs to be installed, COM3 and COM4 may
be needed.
The options are: 3F8/IRQ4 (Default), 3E8/IRQ4, 2E8/IRQ3, 2F8/IRQ3,
Disabled.
Onboard Serial Port 2
If the serial port 2 uses the onboard I/O controller, you can modify your serial
port parameters. If an I/O card needs to be installed, COM3 and COM4 may
be needed.
The options are: 2F8/IRQ3 (Default), 3E8/IRQ4, 2E8/IRQ3, 3F8/IRQ4,
Disabled.
UART 2 Mode
Allows you to select the IR modes if the serial port 2 is used as an IR port.
Set at Standard, if you use COM2 as the serial port, instead as an IR port.
The options are: HPSIR, ASKIR, Standard (Default).
IR Function Duplex
If the option ASKIR of UART 2 Mode is selected, this feature will be shown
in your monitor for allowing you to select the infrared transmaction modes.
The options are: Half (Default), Full.
RxD , TxD Active
If the option ASKIR of UART 2 Mode is selected, this feature will be shown
in your monitor for allowing you to select the active level of the reception
end (RxD) and tranmission end (TxD). The Hi stands for Active, the Lo
stands for Non-active.
The options are: Hi, Hi (Default); Hi, Lo; Lo, Hi; Lo, Lo.
Onboard Parallel Port
Allows you to select from a given set of parameters if the parallel port uses
the onboard I/O controller.
The options are: 378H/IRQ7 (Default), 278H/IRQ5, 3BCH/IRQ7, Disabled.
Onboard Parallel Mode
Allows you to connect with an advanced printer I/O mode.
The options are: SPP (Default), EPP/SPP, ECP, ECP/EPP.
ECP Mode Use DMA 3