FIBARO Switch 2 FGS-2 3 Series, Operating Manual

Page: 10 / 26

10
OPERATInG THE DEVICE
Resetting the Switch 2:
1. Switch off the mains voltage (disable the fuse).
2. Remove the Switch 2 from the wall switch box.
3. Switch on the mains voltage.
4. Press and hold the B-button to enter the menu.
5. Wait for the visual lED indicator to glow yellow.
6. Quickly release and click the B-button again.
7. After few seconds the device will be restarted, which is signalled
with the red lED indicator colour.
NOTE
Resetting the device is
not the recommend-
ed way of removing
the device from the
Z-Wave network. use
reset procedure only
if the primary con-
troller is missing or
inoperable. Certain
device removal can be
achieved by the pro-
cedure of removing
described in “Adding/
removing the device”
on page 8.
i
Menu allows to perform Z-Wave network actions. In order to use the
menu:
1. Switch off the mains voltage (disable the fuse).
2. Remove the Switch 2 from the wall switch box.
3. Switch on the mains voltage.
4. Press and hold the B-button to enter the menu.
5. Wait for the lED to indicate the desired menu position with colour:
• GREEN
- reset energy consumption memory
• VIOLET
- start range test
• YELLOW
- reset the device
6. Quickly release and click the B-button again.
Controlling the Switch 2 using the B-button:
The Switch 2 is equipped with a B-button, which allows to use the
menu and perform the following actions:
1x click:
• Cancel alarm mode (flashing alarm).
• Select desired menu position (if menu is active).
• Exit range test.
• Turn 1st channel On/OFF.
3x click:
• Send the node Info Z-Wave command frame (adding/removing).
Hold:
• Enter the menu (confirmed by the lED indicator).